Nikon COOLPIX S203 User Manual Page 145

  • Download
  • Add to my manuals
  • Print
  • Page
    / 164
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 144
133
Caring for the Camera
Technical Notes
Cleaning
Do not use alcohol, thinner, or other volatile chemicals.
Storage
Turn the camera off when not in use. Check that the power-on lamp is off before
putting the camera away. Remove the battery if the camera will not be used for an
extended period. Do not store the camera with naphtha or camphor moth balls, or
in any of the following locations:
Next to equipment that produces strong electromagnetic fields, such as
televisions or radios
Exposed to temperatures below –10 °C (14 °F) or above 50 °C (122 °F)
Poorly ventilated or subject to humidities of over 60 %
To prevent mold or mildew, take the camera out of storage at least once a month.
Turn the camera on and release the shutter a few times before putting the camera
away again.
C Notes on the Monitor
The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic
common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the
product will not be affected.
White or colored streaks of light may be visible in the monitor with framing of bright subjects. This
phenomenon, known as “smear,” occurs when extremely bright light strikes the image sensor. This
is due to characteristics of the image sensor and does not indicate a malfunction. Smear may also
cause partial discoloration in monitor display with shooting.
Smear does not affect recorded images except when shooting with Continuous set to Multi-
shot 16 and when recording movies. When shooting in these modes, avoiding bright objects
such as the sun, reflections of the sun, and electric lights is recommended.
Images in the monitor may be difficult to see under bright lighting.
The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your
Nikon-authorized service representative.
Lens
Avoid touching glass parts with your fingers. Remove dust or lint with a blower
(typically a small device with a rubber bulb attached to one end that is
pumped to produce a stream of air out the other end). To remove fingerprints
or other stains that cannot be removed with a blower, wipe the lens with a soft
cloth, using a spiral motion that starts at the center of the lens and working
toward the edges. If this fails, clean the lens using a cloth lightly dampened
with commercial lens cleaner.
Monitor
Remove dust or lint with a blower. To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Body
Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry
cloth. After using the camera at the beach or seaside, wipe off any sand or salt
with a dry cloth lightly dampened with fresh water, then dry thoroughly. Note
that foreign matter inside the camera could cause damage not covered by
the warranty.
Page view 144
1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 163 164

Comments to this Manuals

No comments