Nikon DSR-1500AP User Manual download pdf (Page 43)

Playback

Chapter 2 Recording and Playback

13Press the SET (YES) button to confirm the defined value.

The message “NOW SAVING...” is displayed on the monitor screen and

“Saving...” is shown in the time counter display while the new setting is

being saved in memory.

Caution

The new setting may be lost if you power off the unit during the saving

operation. Wait until the saving operation is completed before powering the

unit off.

If you want to discard the changed value

Press the MENU button instead of pressing the SET (YES) button to return

to the menu display, then press the MENU button again to end the menu

operation without saving the changed value into memory.

After the saving operation is completed, the monitor screen and time

counter display return to the REPEAT FUNCTION setting display as

shown in step 9.

14To set point B, refer to steps 5 to 13. (Select “REPEAT END” in step 5, “B

POINT” in step 7, and “B PRESET” in step 9.)

15Press the MENU button to close the menu.

Cuing Up to Any Desired Position Set as Point A or B

You can set any desired tape position as point A or B and cue up to the set point

when required. To cue up to point A or B, holding down the g or G button in

the menu control section, press the REW button in the tape transport control

section.

For the methods of setting points A and B, see the previous section.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 111 112

No comments

Nikon DSR-1500AP User Manual Page 43