Connect a di-GPS Basic
Connect the DSLR camera and di-GPS Basic as described below.
1. Turn off the camera.
2. Remove the Cap from the 10 pin remote terminal on the camera body.
3. Store the Cap in a safe place.
4. Connect the di-GPS Basic to the camera’s 10 pin remote terminal with
10 pin connector. Do not use any extension cord. The 10 pin
connector must be aligned with the mark on the camera body. Tighten
the locking nut on the 10 pin connector.
5. Turn the camera on.
6. If the di-GPS Basic is properly connected, the camera will display a
blinking icon in the top control panel as the GPS receiver is searching
for a signal. The icon will stop blinking once signal has been
established and the receiver is ready to supply the current position.
di-GPS Basic will automatically to start receive satellites signal when
connecting to the camera. The di-GPS use the power from the camera.
Please disconnect the di-GPS Basic when not in use to save power.
Each satellite broadcasts a digital message that contains two types of
information. One type is ephemeris data, which includes the assigned serial
number of the satellite; the status of the satellite (healthy or faulty); the current
date and time. The second type is almanac data and includes precise orbital
position of every satellite in the system.
At the initialize stage, di-GPS Basic needs all these data for the position fixed.
It usually takes a minute to few minutes to receive all data. An open sky
outdoor environment will enable faster acquisition process. It will take a
longer time at a weak signal environment. Once di-GPS Basic locked to the
satellites, it will take a few seconds for reacquisition even at weak signal
environment.
Note
• Please refer to user manual of your DSLR for more information on taking
photographs with a GPS.
• Be sure to turn off your camera before disconnecting the di-GPS Basic. Do
not connect or disconnect the di-GPS Basic while the camera is on. Failure to
observe this precaution could cause a malfunction of the camera.
• Do not carry the camera by the di-GPS Basic or subject the camera or cord to
physical shocks while the cord is connected. Failure to observe this
precaution could result in physical damage of the cord.
• Re-place the caps on the camera when the terminals are not in use.
Nikon D2HS, D2X, D2XS and D200 are registered trademark or a trademark of NIKON CORPORATION in the United States and/or
other countries.
Fujifilm and S5 Pro are registered trademark or a trademark of FUJIFILM U.S.A., Inc. in the United States and/or other countries.
Canon and EOS are registered trademark or a trademark of Canon Inc. in the United States and/or other countries.
Products and brand names are trademarks or registered trademarks of their respective companies.
V1.00
5
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals