Nikon Coolpix 300 User Manual download pdf (Page 91)

Connections : Making a Serial Port Connection

Connections

This chapter describes how to set up your camera to communicate with a

computer and how to connect your camera to a computer by means of the

serial cables provided in this package or the SCSI cable available

separately as part of the SCSI Kit. Before you can use your camera with a

computer, you will need to install the Nikon View software package

provided with this product. For information on using Nikon View software

to view the contents of your camera’s memory or to transfer recordings to

disk for long-term storage, refer to the Nikon View User’s Manual.

Note: Although the COOLPIX 300 comes equipped with both serial and

SCSI interfaces, only one can be used at a time. You cannot connect the

camera simultaneously to two computers or to two ports on a single

computer. If you wish to change the connection, you will first have to turn

the camera and computer off, disconnect the cable, and then reconnect the

devices using one of the methods described in the following sections.

Making a Serial Port Connection

This section describes how to adjust your camera’s serial-port settings and

how to connect your camera to a computer using the serial cable provided

with the COOLPIX 300.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 115 116

No comments

Nikon Coolpix 300 User Manual Page 91