Nikon Fantasea FD-50N User Manual Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 22
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
Insert D-50 camera and lens in housing:
Mount camera and lens on the removable tray, using the tripod screw.
Slide the tray and camera into the housing tray slot. Make sure it is
completely inserted.
Slide the flash sync cord into the D-50’s hot shoe.
Align the housing controls with the corresponding buttons on the camera.
Take caution to insure the flat sync cord does not get caught in the housing
seal by storing the slack alongside the left side of the camera.
Place housing back over front and align the complete mating surface of the
housing and the gasket, forming a proper seal.
Position all three latches over latch hooks in ready position.
Close all three latches at one time. If it is not possible to close all three
latches at the same time, close the bottom latch first, maintaining pressure
on the other side. Then close the two side latches simultaneously.
Inspect the gasket seal for proper closure. A complete seal can be visually
confirmed by looking for the black line made by the gasket around the
complete circumference of the housing.
Take a Test Dive:
Make the first dive without camera in housing.
This will give you a chance to inspect the housing
seal for proper closure. In this case, any mistakes
will not result in the loss of the camera.
Operate all controls under pressure in the water and
inspect for watertight seal.
Before all dives, immerse the housing in the camera
rinse tank, and press all buttons, to visually inspect
for any leakage.
While descending on every dive carefully observe
the housing. If you see any bubbles rising from it or
water entering surface immediately while holding
the lens port in a downward position. Once on dry
land carefully open the housing, take out the camera
and dry it off if any water is on it and check to see if
there is any damage. Please inspect the housing,
rinse it in fresh water, dry it out and then take a dive
without the camera in the housing to check for leaks
or other malfunctions.
14
Page view 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Comments to this Manuals

No comments