152
Troubleshooting
Technical Notes and Index
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not
recorded to internal memory or the memory card at the time the problem
occurred. Data already recorded will not be affected.
Shooting
Date not imprinted on
pictures even when
Date imprint is enabled.
• The current shooting mode is one that does not
support Date imprint.
• The date cannot be imprinted on movies.
128
Camera settings reset.
Clock battery is exhausted; all settings were restored to
their default values.
125
Monitor turns off, and
the power-on lamp
blinks rapidly.
Battery temperature is high. Turn off camera and allow
battery to cool down before resuming use. After the
lamp blinks for three minutes, the camera will turn off
automatically. Pressing the power switch also turns off
the camera.
17
Battery inserted into the
camera is not charged
when the camera is
connected to a
computer.
• The battery is not charged when the camera is
turned off.
• Charging stops if the computer enters sleep mode
while the battery is charging. The camera may be
turned off.
• Depending upon computer specifications, settings,
and status, it may be impossible to charge the
battery inserted into the camera via computer
connection.
113
Problem Cause/Solution A
No picture taken when the
shutter-release button is
pressed.
• When camera is in playback mode, press the
A button, the shutter-release button, or the
b (movie-record) button.
• When menus are displayed, press the d
button.
• Battery is exhausted.
• When flash lamp blinks, flash is charging.
8, 28
10
22
31
Problem Cause/Solution A
Comments to this Manuals