Nikon P5100 User Manual Page 157

  • Download
  • Add to my manuals
  • Print
  • Page
    / 176
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 156
143
Caring for the Camera
Technical Notes
Cleaning
Do not use alcohol, thinner, or other volatile chemicals.
Storage
Turn the camera off when not in use. Check that the power-on lamp is off before
putting the camera away. Remove the battery if the camera will not be used for an
extended period. Do not store the camera with naptha or camphor moth balls, or
in any of the following locations:
Next to equipment that produces strong electromagnetic fields, such as
televisions or radios
Exposed to temperatures below –10 °C (14 °F) or above 50 °C (122 °F)
Poorly ventilated or subject to humidities of over 60 %
To prevent mold or mildew, take the camera out of storage at least once a month.
Turn the camera on and release the shutter a few times before putting the camera
away again.
B Use Only Nikon Flash Accessories
Use only Nikon Speedlights. Negative voltages or voltages over 250 V applied to the accessory shoe
could not only prevent normal operation, but damage the sync circuitry of the camera or flash.
Before using a Nikon Speedlight not listed in this section, contact a Nikon-authorized service
representative for more information.
C Notes on the Monitor
The monitor may contain a few pixels that are always lit or that do not light. This is a characteristic
common to all TFT LCD displays, and does not indicate a malfunction. Images recorded using the
product will not be affected.
When framing bright subjects, vertical comet-like streaks that whiten toward either end may
appear in the display. This phenomenon, known as “smear,” does not appear in the final
photograph and does not indicate a malfunction. Some smear may appear in movies.
Images in the monitor may be difficult to see under bright lighting.
The monitor is lit by an LED backlight. Should the monitor begin to dim or flicker, contact your
Nikon-authorized service representative.
Lens/
viewfinder
Avoid touching glass parts with your fingers. Remove dust or lint with a
blower (typically a small device with a rubber bulb attached to one end that is
pumped to produce a stream of air out the other end). To remove fingerprints
or other stains that cannot be removed with a blower, wipe the lens with a
soft cloth, using a spiral motion that starts at the center of the lens and
working toward the edges. If this fails, clean the lens using a cloth lightly
dampened with commercial lens cleaner.
Monitor
Remove dust or lint with a blower. To remove fingerprints and other stains,
clean the monitor with a soft, dry cloth, being careful not to apply pressure.
Body
Use a blower to remove dust, dirt or sand, then wipe gently with a soft, dry
cloth. After using the camera at the beach or seaside, wipe off any sand or salt
with a dry cloth lightly dampened with fresh water, then dry thoroughly. Note
that foreign matter inside the camera could cause damage not covered by
the warranty.
Page view 156
1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 175 176

Comments to this Manuals

No comments