Nikon XX152-02-00 User Manual

XX152-02-00 FIXED CAMERA DOME Vicon Industries Inc. does not

Introduction The information in this manual covers the installation, operation, and maintenance of the SurveyorVFT Series of Fixed Camera Domes. This

UTP Receivers V212-NVT 7631 Receiver, converts UTP video to composite up to 500 ft from transmitter V213-NVT 6518 Receiver, converts UTP video t

SurveyorVFT Fixed Dome Components The SurveyorVFT fixed camera dome units consist of an enclosure/housing, a camera mechanism, a shroud, and a smoked

Mounting the Unit In-Ceiling Mounting The SurveyorVFT fixed dome rests on the ceiling material and occupies the space between the lower ceiling and up

2. If cables are used without the use of flexible conduit: a. Remove the enclosure top by loosening the 3 screws. Remove the conduit fitting by loos

3. Working above the ceiling, remove the enclosure top by loosening the 3 screws and lifting it off. If cables are used without the use of flexible c

Installation of Optional In-Ceiling Mounting Kit rveyorVFT fixed camera dome can (such 1. Install the 2. the 1.5-in. NPT pipe, 3. 4. When it bec

Outdoor Pendant The outdoor pendant model mounts on a Vicon mount or a 1.5-in. vertical pipe with an appropriate coupling. e area around the inteThe o

Camera Power Connections Note: Vicon systems and components, like most electronic equipment, require a clean, stable power source. Voltage irregulari

DIP Switch Settings There is a DIP switch on the front camera board that allows the selection of: Switch 1 - ALC (OFF) or ELC (ON); Switch 2 – Interna

Figure 5 Potentiometer/DIP Switch Location Figure 6 DIP Switch Settings XX152-02-00 Rev 1004 SurveyorVFT Fixed Camera Dome Installation • 11

Final Installation In-Ceiling After all cabling is complete, (if not previously done) connect the enclosure’s safety cord clip to camera mechanism to

Figure 8 Camera Mounting Bracket Adjustment – 2.6-6 mm Version Shown with the place on 9. Insert the clip of the safety cord on the lower dome in

Indoor Pendant After all the cabling is complete, push the SurveyorVFT camera mechanism straight up into the housing. Align camera mechanism with the

Outdoor Pendant Note: Assure that there is no extra slack in the cabling that will interfere with proper installation and After all the cabling is co

Disassembly The SurveyorVFT Fixed Camera Dome disassembled by removing the camera mechanism camera mechanism while assembling or disassembling. 1.

Operation When power is applied to the camera, the SurveyorVFT fixed dome views the selected scene. Maintenance The SurveyorVFT Fixed Camera Dome re

Shipping Instructions 1. Call or write Vicon for a Return Authorization (R.A.) at one of the locations listed below. Record the name of the Vicon emp

Reference Coaxial cables used to route video signals to and from the unit must meet the video recommendations in this section. Caution: Careful select

FCC Notice Note: Complies with Federal Communications Commission Rules & Regulations Part 15, Subpart B for a Class A digital device. WARNING Th

Twisted-Pair Cable Caution: Careful selection of the proper cable is essential to obtain the best performance from this equipment. Vicon assumes no r

Technical Information Current: Outdoor: 1.1 A. sent the conversion of 100% of the electrical energy to eat. Actual percentage of heat generated will

Dimensions: In-Ceiling Height: 9.7 in. (246 mm). Total Diameter: 7.1 in. (180 mm). . Total Diameter: 8.0 in. (203 mm). Dome Diameter: 5.9 in. (150 m

1004 SurveyorVFT Fixed Camera Dome Technical Info n • 23 rmatio1/61/61/61/61/1/1/6Table 3 Camera Specifica nsod ma evCoMo nes) Sensitivity fc (lu

24 • Tech nical Information XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome Lens Specifications Model Focal Length (mm) Field-of-View Hor

Vicon Standard Eq ment Warrantuip y Vicon Industries Inc. (the “ be free from defects in material and workmanship under Normal Use from the date thr

Vicon Industries Inc. Corporate Headquarters Fax: 6 51-CCT 288) 31-9 V (2✆Infofax: 800-287-1207 nite om +44 (0) 1489 566300 Fax: +44 (0) 1489

Important Safeguards 12. Power Cord Protection - Power supply cords should not be routed in trafficked areas or in tight spaces where they will be pin

Contents Quick Installation ...ii Introdu

Quick Installation In-Ceiling - No Access to Ceiling ii • Quick Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome

In-Ceiling – Access to Ceiling XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome Quick Installation • iii

Pendant - Indoor iv • Quick Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome

Pendant – Outdoor XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome Quick Installation • v