Nikon KeyMission 360 User Manual download pdf (Page 29)

Getting Started

6 Press and hold down the movie button

on the camera for about 7 seconds to

put it into pairing standby mode.

• When the status lamps flash green at the same

time for a while and then alternately flash green,

the camera enters pairing standby mode.

• If the camera remains in pairing standby mode for

about 4 minutes, it turns off (the power-on lamp

turns off) automatically.

7 Tap a Connect M Connection options.

8 Tap the camera name.

• For iOS:

When the accessory selection screen is displayed after

tapping the camera name, wait for the Bluetooth icon at the

top right corner of the screen to change from white to gray,

and then tap the camera name. It may take a while before

the camera name is displayed.

• If pairing is successful, the screen shown on the right is

displayed.

Status lamps

Connect

Connection options

Select camera

...

KeyMission 360_XXXXXXXX

The smart device will pair with the selected camera via

Bluetooth. If pairing fails, try again following the

instructions in the manual.

Connect

KeyMission 360

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

No comments

Nikon KeyMission 360 User Manual Page 29